Single Bar Vertical Barbell Storage Rack - Wall Mounted Olympic Bar Hanger – Iron Company (IC1BARHANGER)

SKU
WRI-1-BAR-HOLDER
In stock
Olympic Bar NOT Included
$39.00
Single Bar Vertical Barbell Storage Rack - Wall Mounted Olympic Bar Hanger – Iron Company (IC1BARHANGER) is available to buy in increments of 1

IRON COMPANY® Single Bar Wall Mount Olympic Bar Vertical Storage Rack - The Wall Mount Single Bar Hanger from IRON COMPANY is an American-made heavy duty steel bracket for vertical hanging storage of one Olympic weight bar. Everyone knows that space is a limited commodity in any garage gym. To free up space and declutter the training zone, wall mounted workout racks and equipment storage solutions become an important part of any garage gym package purchase. When it comes to storing your favorite Olympic weight lifting bar or power bar, what better way to get it off the rack and off the floor than to hang it conveniently and safely on the wall. Eliminate unwanted denting or dulling of bar sleeve caps, or premature wear on bar sleeve fasteners, since you won't have to worry about impact of bar ends to concrete garage floors when storing upright (or when sliding into fabricated bar holder tubes attached to some racks). And, if you normally just lean your bar up against the garage wall, you won't have to risk accidentally bumping into it and knocking it over causing damage to the bar, other equipment, or even a vehicle parked next to your rack… there's nothing worse than having your bar go through a car window or put a big dent in your door panel!

The IRON COMPANY Single Bar Holder is not made of flimsy sheet metal like some bar hangers that can bend from weight, nor does it use welded posts that can snap off. This hanging rack is fabricated from sturdy 11-gauge steel that goes through laser cutting and computer numerically controlled (CNC) bending. This Olympic weight bar holder accommodates standard length Olympic bars, Olympic "shorty" bars, and even Olympic curl bars since the bar will hang downward from the inside collar at the end of one sleeve. The spacing between the two rungs of the hanging bar rack is wide enough to fit traditional barbell shafts from 25mm to 32mm in diameter. Two pre-drilled mounting holes allow for secure installation.

Looking for additional storage solutions for your garage gym? Contact an IRON COMPANY® home gym specialist today at 1-888-758-7527 or email quotes@ironcompany.com.

FEATURES:

  • Includes (1) Wall Mounted Single Bar Hanger
  • Proudly MADE IN THE USA
  • Single wall mounted bracket holds ONE Olympic bar vertically
  • Intended for installation to wood backer board, wood wall studs or masonry
  • Mounting hardware NOT included
  • Olympic bar sold separately
There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

SPECIFICATIONS:

  • Construction: 11-gauge steel produced by laser cutting and CNC bending
  • Finish: Powder coated Black
  • Width: 2.75 inches
  • Height: 9 inches
  • Depth: Extends 3.75 inches from wall
  • Mounting Holes: Two, 1/2 inch diameter, pre-drilled
  • Weight: 2 pounds

WARRANTY:

LIFETIME warranty for structural integrity

INSTALLATION RECOMMENDATION:

It is strongly recommended to hire a professional to ensure proper installation to wall with correct type of hardware as well as account for load bearing tolerances of mounting hardware and wall. As an example for load bearing test, one traditional full-size Olympic bar weighs 45 pounds, and the rack has a weight of 2 pounds (so 47 pounds total weight affixed to wall). Regularly inspect the Wall-Mounted Barbell Hanger at attachment points to ensure that the product is safe and secure for its intended storage usage and load weight.

SHIPPING:

  • Ships by FedEx Ground
  • Shipping cost included within the lower 48 states only
  • Additional shipping cost applies to AK, HI, PR